What is the BEST way to wire my Ampeg SVT 4 Pro Bass head to my Cabinet Speakers.?

Sep 08, 2009 by dfro86nap | Posted in Other - Electronics

I have an Ampeg SVT 4 Pro Bass head that has 1600 watts.
My set up is currently an Ampeg PR 4X10hlf and also an Ampeg 1x15.
The 4x10 has 4 ohms and 650 watts rms and the 1x15 i think has 250 watts and is 8 ohms.

CURRENTLY

---

That amp will drive 2 Ohms so you could just parallel both cabs together and run the amp as a mono bridged output.

The other option (like you have it) is to run each cab in the Biamp mode

You will get a bit more power if

Ampeg's SVT-4pro Bass Head

SVT-4PRO offers an expansive palette of tonal options. The Frequency control allows you to select the center frequency for the Midrange control ...

Ampeg Svt 4 Pro Head / Gator G-tour Rack / Footswitch | Musical ...

by wthompsonjr

Hi, I bought this “Made in the USA”, AMPEG SVT-4 PRO amp used about 2 years ago for a project then never used it. I bought it , installed new electro-harmonix tubes, bought a new GATOR G-TOUR 4 space rack ($239. My intention was to use this to run 2- SVT 810 cabs… however … I decided to go with 2 SVTCL heads instead. 99) and found an AMPEG AFP-3 footswitch to use with this head. I made 2 – Neutrik to 1/4″ speaker cables ( about 3 feet long) and I also made a 3′ neutrik to neutrik cable to use in bridge mode. I will ship this amp , in the case, with the footswitch and 3 cables to continental 48 states only using UPS ground to confirmed addresses only. NO SHIPPING OUTSIDE THE USA… PERIOD…MUST HAVE A VALID U. P. S SHIPPING ADDRESS....

Read more...